It serves you to check the flow rate of thermal transfer liquids and container heating liquids. Get 8000 series flow meter. It will assist you in controlling the speed of fluid flow at low and high temperatures. This high-temperature flow meter will provide you specific data. As an outcome, the results of heat transfer liquids are safe and sound. 

How It Works

As fluid passes by the flow sensor pit, the rotor turn magnets are set in the rotor switch. A Hall Effect sensor is located in the sensor body. A microcomputer controls the rotor's spinning rate, and computing features seen in flash memory let the volumetric flow rate be measured. Flow rate results are 0–5 or 0–10 VDC and 4–20 mA. A built-in relay is scheduled to turn when the estimated flow rate drops below a chosen alarm value. A bright LED flow state symbol is green when the flow rate is at normal operation levels, bay if it sinks under a set alarm border, and red sinks below the alarm flow rate.

How to install 8000XHT Series

The internal diameter of pipes that come in and devices connected to its inlet changes the flow response of 8000XHT. Therefore, upstream devices might influence how it goes. That is why you need to have a run of upright pipe. The pipe should have a length of not less than ten times the internal pipe diameter. Ensure the pipe is set between the flow meter and the upstream devices.

When you are done with connections, turn on the fluid flow but secure to be slow. That will help you to identify leaks and tighten the link to stop all leaks. Do not forget to discharge air in the flow basin of your 8000XHT flow meter.

Traits of 8000 series liquid flow meters

• Flow ranges from 0.2 to 227 LPM / 0.05 to 60.0 GPM
• The efficacy of 3% of the flow series
• Liquid temperatures from 40 to 90°C for usual models personalized versions to 150°C and over.
• Improved efficiency and security from digital signal functioning
• AutoAlarm electric alarm trip point setting feature
• General NEMA 4X / IP66 forms
• 5-year guarantee

Guide on 8000XHT high-temperature flow meter works

The 8000XHT high-temperature flow meter has a distinct process by which it works. It operates based on attached magnets that alternate. For instance, the 8000 series has north and south magnets. They change as water flows by the sensor basin. That will then create a revolution in the rotor.

As an outcome of the spinning rotor, two flux hubs were given and then to the switch. The switch is two hall influence sensors set on the chief electronics board. In addition, 8000XHT has an embedded microcomputer that serves to control the rotational rate of the rotor. It then compares the features to clear memory that holds the mass of the liquid flow rate.  

Conclusion

8000XHT Series high-temperature flow meter can give you excellent results of the flow rate of the controlled liquids. It runs uniquely. Once you have set it, ensure to check regularly. The fitting process is not challenging, but it is crucial to have a technician.